Watch for regular maintenance
First of all, we watch Structurally, why watches require regular maintenance.
First, watch sealing problems. Most watches are an indication of water, such as 30M, 50M, 100M and so on. Also part of the state is not waterproof. As the structural needs, some water and some do not waterproof, not to say that water is not good form of watches, many more than ten dollars on the market can be waterproof plastic sheet, should it be watches it? Another is an indication of waterproof watches, is also produced when tested that is waterproof, but can not guarantee that you do not care to use lifetime waterproofing. For example many customers bought the count table table wearing bathing, and occasionally one or two felt no water, but after a few times to find water, and into the water not in time, which began to rust over time, go to the store reported poor quality of goods to return. On the other hand, can not wear any watch to go to saunas and hot water bath, as plastic pads shrink, the hot air into the sealed bag and can not come out, causing the fog is not in time, cause corrosion, rust, so watch watches can only be worn under normal circumstances. In fact, waterproof watches, mainly by a small number of rubber band work, over time the rubber ring will be aging, loss of flexibility in there after the gap, it could lead to water, air, so to replace the rubber seal ring on a regular basis to ensure the watch Waterproof.
Second, mechanical operation. Lists are generally mechanical watches, mechanical watches, they all rely on gear operation, we see the watch will indicate the number of drill watch, watch the number of drilling does not mean that the number of diamonds, but rather that the number of watch gear shaft is Drill eye, generally replaced with man-made diamonds, synthetic diamonds, as wear resistance, so the table drilling and more time to go watch a relatively longer life span. However, the gear can not watch with diamonds so hard to process materials, it can only steel material as the wheel, watches the smaller the more books, more small wheel, turn the switch a few tens of thousands each day fully leaned inside the drill hole trace oil to reduce wear and tear, if the oil dried in a dry wheel wear, a few years, this table also to the life, even though the table watches are very high oil, but because the amount is too small, a few years certainly would evaporate End, an like the same hair shaft can wear thin over time? The previous table structure does not present complex, and do relatively large wheel is also fairly thick, so some customers said that my table to go ten years without maintenance are now the table get smaller, the price of your scores than before times, the emotion can not hold as before.
3, appearance and maintenance. The general appearance of gold watches with K, K Platinum, senior animal leather. K gold although the main raw material is gold, but the sweat is acidic hands with the air of corrosion, over time, when the new pretty far, which require frequent washing, polishing, making watches to keep Changxin. If K white gold, silver layer and wear out over time, which gold exposure, it not as white, so it needs regular maintenance coating of white, to maintain Changxin. Not to mention the leather strap, sweat premature hardening corrosion cracking will belt, regular maintenance should avoid wearing a belt table during the wet sweat. If the watch is made of steel case and strap, regular polishing renovation to better reflect its value.
So for watches, the maintenance of good or bad, will have a direct impact on its value.
News for Tuesday 31 August, 2010
View all news for Tuesday 31 August, 2010 on one page
Recent News